|
Unit
|
Lab
|
Materials
|
| 3 |
Building a Capacitor
Note: The digital multimeter and the copper wire needed for this lab is included in the myscience-prep lab kit for E&M.
|
- Aluminum foil
- Magazine paper
- Masking tape
- Copper wire
- Digital multimeter that can measure capacitance
|
|
4
|
Simple Light Bulb Circuits
Note: The equipment needed for this lab is included in the myscience-prep lab kit for E&M.
|
- Two AA Batteries (1.5 v, Alkaline)
- Two AA Battery Holders
- 10 pack of 14 inch jumper wires with alligator clip ends
- Four flashlight bulbs
- Four bulb holders
|
| 4 |
RC Circuit Analysis
Note: All items needed for this lab, except for the stopwatch, are included in the myscience-prep lab kit for E&M.
|
- One 1000 microfarad capacitor
- One 9-v battery
- One 20000-ohm resistor
- Jumper wires with alligator clip ends
- Stopwatch
- Digital multimeter
|
| 5 |
Magnet and Compass
Note: The magnets, iron filings, paper clips, and compass needed for this lab are included in the myscience-prep lab kit for E&M.
|
- 2 small round ferrite magnets (6mm x 2 mm)
- 2 small round neodymium magnets (6mm x 2 mm)
- 1 magnetic compass
- 1 ruler
- 1 protractor
- 1 electronic balance
- Iron filings
- String
- Tape
- 1 red sharpie pen or other felt-tipped marker.
- Lots of paper clips
|
|
5
|
Electromagnets
Note: The equipment needed for this lab is included in the myscience-prep lab kit for E&M.
|
- One large iron nail
- Copper wire
- One 9-volt (the type you put in a smoke detector)
- One 1.5-volt D-cell (the type you put in a flashlight)
- Lots of paper clips
|
| 6 |
Faraday's Law
Note: The equipment needed for this lab is included in the myscience-prep lab kit for E&M.
|
- Several disk-shaped magnets
- One 1.5 volt battery
- Copper wire
|
